Initial upload of the Physical Flick keyboard files.

mozc-furikku/README.md

@@ -0,0 +1,93 @@
+Copyright 2016 Google Inc.
+
+Licensed under the Apache License, Version 2.0 (the "License");
+you may not use this file except in compliance with the License.
+You may obtain a copy of the License at
+
+    http://www.apache.org/licenses/LICENSE-2.0
+
+Unless required by applicable law or agreed to in writing, software
+distributed under the License is distributed on an "AS IS" BASIS,
+WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+See the License for the specific language governing permissions and
+limitations under the License.
+
+
+ Summary
+=====================================
+
+Circuit diagram and firmware of Google Japanese Input physical flick version.
+
+
+ Files
+=====================================
+
+* README.md  -- this file
+* arduino/flick/*  -- firmware source code (Arduino sketch)
+* circuit.png  -- circuit diagram
+
+
+ Building your device
+=====================================
+
+## Electronic parts
+
+* Arduino Nano * 1
+* RN-42-I/RM * 1
+* SJoys 2-axes joystick module (Sainsmart) * 12
+* 0.1uF ceramic capacitor * 4
+* 470 ohm resistor * 1
+* 1k ohm resistor * 1
+* Connectors
+
+## RN42 configuration
+
+This step is required for the first time, or when changing the device's name.
+See Microchip's documents for detail.
+
+1. Run a terminal emulator and open the serial port for Arduino.
+2. Type '!' to enter pass-through mode.
+3. Type '$$$'.
+4. Configure the module by these commands:
+
+* * * * * *
+    SU,115k
+    SM,6
+    SA,2
+    S~,6
+    SH,0000
+    SN,MY_PHYSICAL_FLICK_KEYBOARD
+    R,1
+* * * * * *
+MY\_PHYSICAL\_FLICK\_KEYBOARD is a device name that will appear when you scan
+Bluetooth devices, and can be replaced by your preferred name.
+
+The commands will configure the module as follows:
+
+* 115200bps
+* Pairing mode
+* SSP "just works" mode
+* SPP profile
+* HID flag register = 0 (keyboard)
+
+
+ Using flick input
+=====================================
+
+## Power supply
+
+When operating the device, supply power by USB cables to Arduino Nano.
+
+## Bluetooth pairing
+
+Using your device (e.g. Android phone), scan Bluetooth devices and you will
+find MY\_PHYSICAL\_FLICK\_KEYBOARD (or the name you set up) in the available
+device list.
+
+After pairing, find the device in the "physical keyboard" section and choose
+"English - U.S." keyboard layout for it.
+
+## How to input
+
+Switch the Japanese IME on the paired device to romaji input mode.
+Characters will be input as flick or press a key.