Alexey Zholtikov 7662593a30 Version 2.0.0
Added support AM2320 sensor.
Major main code refactoring.
2024-06-23 09:49:31 +03:00

73 lines
2.1 KiB
C

#pragma once
#include "stdint.h"
#include "stdio.h"
#include "esp_err.h"
#include "esp_log.h"
#include "driver/gpio.h"
#ifdef CONFIG_IDF_TARGET_ESP8266
#include "driver/i2c.h"
#else
#include "driver/i2c_master.h"
#endif
#include "freertos/FreeRTOS.h"
#include "freertos/task.h"
#define ZH_DHT_INIT_CONFIG_DEFAULT() \
{ \
.sensor_pin = 0xFF, \
.i2c_port = 0 \
}
#ifdef __cplusplus
extern "C"
{
#endif
typedef struct
{
uint8_t sensor_pin; // Sensor GPIO connection.
bool i2c_port; // I2C port.
#ifndef CONFIG_IDF_TARGET_ESP8266
i2c_master_bus_handle_t i2c_handle; // Unique I2C bus handle.
#endif
} zh_dht_init_config_t;
/**
* @brief Initialize DHT sensor.
*
* @param[in] config Pointer to DHT initialized configuration structure. Can point to a temporary variable.
*
* @attention I2C driver must be initialized first (for I2C connection only).
*
* @note Before initialize the sensor recommend initialize zh_dht_init_config_t structure with default values.
*
* @code zh_dht_init_config_t config = ZH_DHT_INIT_CONFIG_DEFAULT() @endcode
*
* @return
* - ESP_OK if initialization was success
* - ESP_ERR_INVALID_ARG if parameter error
* - ESP_ERR_NOT_FOUND if sensor not connected or not responded (for I2C connection only)
*/
esp_err_t zh_dht_init(const zh_dht_init_config_t *config);
/**
* @brief Read DHT sensor.
*
* @param[out] humidity Pointer for DHT sensor reading data of humidity.
* @param[out] temperature Pointer for DHT sensor reading data of temperature.
*
* @return
* - ESP_OK if read was success
* - ESP_ERR_INVALID_ARG if parameter error
* - ESP_ERR_NOT_FOUND if DHT is not initialized
* - ESP_ERR_INVALID_RESPONSE if the bus is busy
* - ESP_ERR_INVALID_STATE if I2C driver not installed or not in master mode
* - ESP_ERR_TIMEOUT if operation timeout
* - ESP_ERR_INVALID_CRC if check CRC is fail
*/
esp_err_t zh_dht_read(float *humidity, float *temperature);
#ifdef __cplusplus
}
#endif