Response to reset pulse

include/zh_onewire_slave.h

@@ -0,0 +1,46 @@
+#pragma once
+
+#include "esp_err.h"
+#include "esp_log.h"
+#include "driver/rmt_tx.h"
+#include "driver/rmt_rx.h"
+#include "driver/gpio.h"
+#include "freertos/FreeRTOS.h"
+#include "freertos/task.h"
+#include "freertos/queue.h"
+#include "esp_timer.h"
+
+#define ZH_ONEWIRE_SLAVE_INIT_CONFIG_DEFAULT() \
+    {                                          \
+        .bus_pin = GPIO_NUM_5,                 \
+        .task_priority = 4,                    \
+        .stack_size = 2048}
+
+#ifdef __cplusplus
+extern "C"
+{
+#endif
+
+    typedef enum
+    {
+        ZH_DS1820 = 0x10 // DS1920, DS1820, DS18S20, DS18B20.
+    } zh_onewire_slave_device_type_t;
+
+    typedef struct
+    {
+        zh_onewire_slave_device_type_t device_type;
+        uint8_t device_rom[8];
+    } zh_onewire_slave_device_handler_t;
+
+    typedef struct
+    {
+        uint8_t bus_pin;       // Onewire bus GPIO connection. @attention Must be pull-up to the VCC via 4.7K resistor.
+        uint8_t task_priority; // Task priority for the onewire messages processing. @note It is not recommended to set a value less than 4.
+        uint16_t stack_size;   // Stack size for task for the onewire messages processing. @note The minimum size is 2048 bytes.
+    } zh_onewire_slave_init_config_t;
+
+    esp_err_t zh_onewire_slave_init(const zh_onewire_slave_init_config_t *config);
+
+#ifdef __cplusplus
+}
+#endif