28 lines
1.1 KiB
Markdown
28 lines
1.1 KiB
Markdown
# AVR firmware for wireless touch pad (nRF24L01+)
|
|
|
|
## Features
|
|
|
|
1. Wireless touch pad sensor for ATMega 168/328 microcontrollers with nRF24L01+ transceiver.
|
|
2. Power consumption in the sleep mode approximately 2 uA.
|
|
3. Transmits device identifier and battery voltage level on each touch event.
|
|
4. Battery measurement through internal ADC with 1.1 V bandgap reference.
|
|
5. Wake-up from power-down mode by external interrupt on rising edge.
|
|
6. Supports ATMega168, ATMega168P, ATMega168PB, ATMega328, ATMega328P, ATMega328PB.
|
|
7. Easy installation into any standard touch pad enclosure.
|
|
|
|
## Attention
|
|
|
|
1. A compatible RF Gateway is required to receive and process transmitted packets.
|
|
2. After power-on reset the first touch event may not trigger a transmission.
|
|
3. Multi-touch is not supported, only a single touch event per transmission cycle.
|
|
4. Changing gateway address or channel requires reflashing the microcontroller.
|
|
|
|
## Using
|
|
|
|
In an existing PlatformIO project, run the following command to install the firmware:
|
|
|
|
```bash
|
|
cd your_project
|
|
git clone https://github.com/aZholtikov/zh_avr_touch_pad
|
|
```
|